Adding Versamax Profinet Scanner Power Supplies - Emerson PACSystems RX3i User Manual

RSTI-EP PROFINET I/O Controller User Manual
GFK-2571R
Figure 62: PNS Port Parameter Details
3.7.2

Adding VersaMax PROFINET Scanner Power Supplies

The VersaMax PNS has connectors for either one or two power supplies. If necessary,
additional power supplies can also be located between modules in the remote node.
To configure the one or two power supplies that will be installed directly on the PNS module,
right-click on the Slot 0 icon in the Navigator, then select Change Submodule List. A list of
VersaMax power supplies appears.
In the Submodule list for slot 0, expand the Power Supply list and select the desired power
supply from the list. Drag the selected power supply to an available slot in the left pane. Slot
0, Subslot 2 is the leftmost power supply slot. Slot 0, Subslot 3 is the rightmost power supply
slot. (To delete a module after moving it, select the module on the left and press the
keyboard Delete key).
Figure 63: Selecting Power Supply for PNS Rack
Click OK to add the selected module(s) to the configuration. The Navigator shows the added
power supply or power supplies under slot 0.
Figure 64: Power Supplies Displayed in PNS Rack
Configuration
Section 3
May 2021
69