Exploring Profinet Networks - Emerson PACSystems RX3i User Manual

RSTI-EP PROFINET I/O Controller User Manual
GFK-2571R
Figure 35: Setting PROFINET System Redundancy Parameters in PAC MACHINE
EDITION Inspector
CPE100/CPE115 does not support PROFINET System Redundancy.
Note:
3.5

Exploring PROFINET Networks

To explore the PROFINET networks in the system while PAC Machine Edition is online with
the RX3i system, and while the PROFINET Controller is connected to its network, right-click
on the Target icon (not the PNC) and select Explore PROFINET Networks under the Online
Commands menu item.
The Explorer view shows version information about all the devices on the associated
network. Figure 36 shows a PNC001 (located in Slot 6 of its CPU rack) with a single VersaMax
PNS on its network. Figure 37 shows an embedded PROFINET Controller (embedded in a
CPE330 / CPE400 / CPL410 / CPE100/CPE115) connected to an RX3i PNS module.
Note that all modules physically present in the remote nodes controlled by the PNS are
displayed, regardless of whether the devices are configured or not.
Configuration
For LED behavior and operator-initiated Role Switching in Hot Standby Systems, refer to
the Quick Start Guide or product manual of the device itself. These topics are not covered
in this manual.
Section 3
May 2021
55