Profinet Controller Faults In The Pacsystems Fault Tables; Clearing The Pacsystems Fault Tables; Faults Reported To The Pacsystems Controller Fault Table - Emerson PACSystems RX3i User Manual

RSTI-EP PROFINET I/O Controller User Manual
GFK-2571R
5.9 PROFINET Controller Faults in the PACSystems
Fault Tables
The PROFINET Controller logs all (Local, Controller, I/O) faults in its Local Log. In addition, it
passes Controller and I/O faults to the PACSystems CPU where they are logged in the
corresponding CPU fault Tables (the Controller Fault Table or the I/O Fault Table).
5.9.1

Clearing the PACSystems Fault Tables

• Clearing one or both CPU's fault tables has no effect on the Local Log table in the
PROFINET Controller. The Local Log in the PROFINET Controller can only be cleared via
a CLI command (applies to PNC001-Ax module only).
• Clearing one or both CPU's fault tables has no effect on the Diagnosis conditions
maintained by any IO-Device.
•
When the PACSystems CPU's fault tables are cleared, PROFINET-related faults are NOT
re-reported, even if the condition that is causing the fault still exists.
5.9.2 Faults Reported to the PACSystems Controller Fault
Table
The following PROFINET Controller-related faults are reported in the Controller Fault Table
of the PACSystems CPU, in addition to being listed in the Local Log Table of the PROFINET
Controller.
Group-
Error Code
11-67
Diagnostics
Description Cause
Unable to deliver PROFINET Controller has
configuration to been
module. feature(s) that are not
supported by the version
of PROFINET Controller
firmware in use
Recommended Correction
Upgrade the PROFINET Controller
configured for to its latest firmware or disable
unsupported
configured for the PROFINET
Controller.
supported for each firmware
revision can be found in the RX3i
PROFINET
Product Information, GFK-2573.
This document may be found on
the support website.
Section 5
May 2021
feature(s)
The features
Scanner Important
112