Alarms; Displaying The Alarms To The User - Electrolux EWM10931 Service Manual

4 ALARMS

4.1 Displaying the alarms to the user

When a problem arises in the appliance, a "WARNING" or an "ALARM" is displayed with three digits, where
the time until the end of the cycle is represented.
Series 7
The alarms displayed to the user are listed below:
E10 - Water fill difficulty (tap closed)
E20 - Drain difficulty (filter dirty)
E40 - Door open
The alarms listed below:
EF0 – Water leakage (Aqua Control System)
For its solution, the intervention of a Service engineer is required
While for the alarm:
EH0 – Voltage or frequency outside the normal values
It is necessary to wait for power supply voltage and/or frequency to restore normal conditions.
The alarms are enabled during the execution of the washing programme. With the exception of alarms
associated with the configuration and the power supply voltage/frequency, which are also displayed during
the programme selection phase.
The door can normally be opened (except where specified) when an alarm condition has occurred, on
condition that:
•
The level of the water in the tub is below a certain level.
• The water temperature is lower than 55 °C.
•
The motor has stopped.
Certain alarm conditions require a drain phase to be performed before the door can be opened for
safety reasons:
• Cooling water fill if the temperature is higher than 65 °C
•
Drain until the analogue pressure switch is on empty, during a max. 3-minute time.
2011 SOE/DT-mdm FCPD-dp Quality tb
Guide to diagnostics of electronic controls EWM10931
Series 8
10/75
Series 9
599 73 77-37