Electrolux EWM10931 Service Manual page 9

- Door safety interlock
- Wash solenoid if the water level
in the tub does not cover the
8
heating element
- Motor (55 rpm clockwise,
55 rpm anticlockwise, pulse at
250 rpm)
- Door safety interlock
- Drain pump
9
- Motor up to 650 rpm then at
maximum spin speed (**)
10
-------
11 - Reading/Deleting the last alarm
- The LEDs, groups of symbols in
the LCD screen and the
backlight of the display are
12
turned on in sequence
÷
- Press a button/sensor to turn on
16
the group of icons in the LCD
screen or the corresponding LED
and the buzzer sounds at the
same time
(*) In most cases, this time is sufficient to check the heating. However, the time can be increased by repeating the phase without draining the
water: pass for a moment to a different phase of the diagnostic cycle and then back to the heating control phase (if the temperature is higher
°
than 80 C, heating does not take place).
(**) The check at the maximum speed occurs without control of the AGS and no garments must be inside the appliance.
2011 SOE/DT-mdm FCPD-dp Quality tb
Guide to diagnostics of electronic controls EWM10931
-------
Door closed
Check for leaks
Water level above
from the tub
the heating element
Drain,
Door closed
calibration of
Water level lower
analogue
than anti-boiling
pressure switch
level for spinning
and spin
-----
-------
User interface
Always active
functions
9/75
Drum speed in
rpm/10
Drum speed in
rpm/10
----
-------
599 73 77-37