Table of Contents
Advertisement
4.4 ALARMS
4.4.1 Displaying the alarms to the user
When a problem arises with the appliance, "WARNING" appears on the LCD screen, represented by a code
(three digits, indicating the time required for the cycle to end). At the same time the buzzer gives off three
short "beeps" every 20" for a period of 5 minutes.
Once the fault has been repaired the buzzer does not give off any "beeps" and the selected programme
appears on the LCD screen.
This does not occur for EH0
The alarms displayed to the user are listed below and can also be eliminated by the user:
E10 – Water fill difficulty (tap closed)
E20 – Drain difficulty (filter dirty)
E40 – Door open
EF0 – Excessive detergent
EH0 – Voltage or frequency outside the normal values
While the alarm listed below:
EF0 – Water leakage (Aqua Control System)
For its solution, the intervention of a Service engineer is required
The other alarms are displayed by a code
The alarms are enabled during the execution of the washing programme. With the exception of alarms
associated with the configuration and the power supply voltage/frequency, which are also displayed during
the programme selection phase.
The door can normally be opened (except where specified) when an alarm condition has occurred, on
condition that:
The water in the tub is below a certain level.
The water temperature is lower than 55°C.
The motor has stopped.
Certain alarm conditions require a drain phase to be performed before the door can be opened for safety
reasons:
Cooling water fill if the temperature is higher than 65°C
Drain until the analogue pressure switch is on empty, during a max. 3 minute interval.
2013 TS/DT-mdm FCPD-dp
Guide to diagnostics of EWX11831 electronic controls
alarm.
TC 4
TC4 / TC3
TC4 / TC3
TC 3
12/71
599 77 00-82 Rev. 01
Advertisement
Table of Contents
