Alarms; Displaying User Alarms - Electrolux EWF1284EDW Service Manual

7 ALARMS

7.1 Displaying user alarms

When a problem occurs in the appliance, the LCD display shows a "WARNING", represented by a code (in the
three digits, where the remaining time for the cycle to finish is shown) and simultaneously the buzzer emits
three short beeps every twenty seconds for five minutes.
Once the fault has been repaired/solved, the buzzer stops beeping and the LCD display shows the chosen
programme.
This does not occur for alarm EH0.
The alarms displayed to the user are listed below and can also be eliminated by the user:
E10 – Water fill difficulty (tap closed)
E20 – Drain difficulty (filter dirty)
E40 – Door open
EF0 – Excessive detergent
EH0 – Voltage or frequency outside the normal values
While the alarm listed below:
EF0 – Water leakage (Aqua Control System)
The intervention of a service engineer is required.
The other alarms are displayed by a code.
The alarms are enabled during the execution of the washing programme. With the exception of alarms
associated with the configuration and the power supply voltage/frequency, which are also displayed
during the programme selection phase.
The door can normally be opened (except where specified) when an alarm condition has occurred, on condition
that:

The water in the tub is below a certain level.

The water temperature is lower than 55°C.

The motor has stopped.
Certain alarm conditions require a drain phase to be performed before the door can be opened for safety
reasons:

Cooling water fill if the temperature is greater than 65°C.

Drain until the analogue pressure switch is on empty, during a max. 3-minute interval.
Technical Support - MDM
TC4
TC4/TC3
TC4/TC3
32/97
TC3
599 76 11-68 Rev. 01