Remote Commands - Brother MFC-6650MC Owner's Manual

Remote Commands

Follow the commands below to access features remotely. When you call the
MFC and enter your Remote Access Code (1 5 9 ), the system will signal you
with two short beeps to enter a remote control command.
Remote Control Commands
95 Changing Fax Forwarding/
Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON
7 Fax Storage OFF
96 Retrieve FAX
1 Memory Status List
2 Retrieve all faxes
3 Erase fax from
the memory
97 Check the receiving status
1 FAX
98 Change Answer Mode
1 TAD
2 FAX/TEL
3 FAX
90 Exit
R E M O T E F A X O P T I O N S
Operation Details
If you hear one long beep, the change is
accepted. If you hear three short beeps, you
cannot change it because the conditions have
not been met. (Example: registering paging
number). You can register your fax forwarding
number by using 4. FAX FWD NO (see page
95). Once you have registered the number, the
MFC will change automatically to FAX
FWD:ON mode. Then retrieve a Memory
Status List by entering 961 (see page 107) to
make sure that the Fax Forwarding number you
registered is correct on the List.
You can set FAX STORAGE to ON or OFF.
Enter the number of a remote fax machine to
receive the Memory Status List or stored fax
message(s). (See page 107).
If you hear one long beep, you can erase fax
message(s) from the memory.
You can check whether your MFC has received
any fax message(s). If yes, you will hear one long
beep. If no, you will hear three short beeps.
If you hear one long beep, you can change the
Answer Mode. If you hear three short beeps, you
cannot change it.
After a long beep, you can exit remote control.
83