For Dos Users; How To Use The Mfc With Your Dos Application Software - Brother MFC-6650MC Owner's Manual

122
C H A P T E R T H I R T E E N

For DOS Users

How to Use the MFC with Your DOS Application
Software
Before working with your application software that runs on DOS, check that
the MFC's name appears in the printer selection of your application
software. If the MFC is not listed, you must install the printer driver that
corresponds to HP LaserJet IIP's emulations.
The following table shows combinations of printer drivers and emulation
mode. To get the most out of this MFC, you should install an HP printer
driver in your application software.
Printer driver supported in
your application software
HP LaserJet IIP™
HP LaserJet II™
• The best or recommended printer driver is indicated in bold.
• Be sure to choose the proper printer driver in your application software.
• Be sure the printing resolution is set to 300 dpi in your DOS application
software.
Emulation mode to be selected with
the remote printer console program
HP LaserJet IIP emulation mode
Auto emulation selection