Mp Pe Sub Actuator; P Feed /Size-Sw Pcb Assy; Side-Switch Spring - Brother HL-1260 Service Manual

1.14 MP PE Sub Actuator

(1) Pull out the actuator upward from the MP tray assy (pay attention to the hook because it is fragile).

1.15 P Feed /Size-SW PCB Assy

(1) Put the 3 chassis L tabs to their original position.
P feed/ size -SW PCB assy
Paper feed motor
harness connector
(2) Unplug the 2 solenoid connector and the paper feed motor harness connector.
(3) Loosen the 2 screws of the size-sw PCB.

1.16 Side-Switch Spring

(1) Pull out the size-switch spring.
Figure 4.26
Tabs
2 screws
Figure 4.27
Figure 4.28
IV - 12
MP PE sub actuator
2 solenoid harness
connector
Size-switch spring
Size-SW PCB