Advertisement
1.10 Scanner Unit
(1) Unplug the LD PCB harness (scanner flat cable) connector (6P), and polygon harness (5P).
(2) Remove the beam from the body by loosening the screws.
(3) Remove the scanner unit from the body by loosening the screws.
Caution:
Do not disassemble the scanner unit, it can be only adjusted at the factory.
Polygon harness 5P
Scanner flat cable 6P
1.11 Cartridge Stopper Assy
(1) Loosen 4 screws and remove the scanner mount plate in the direction of the arrow (the
ground leaf spring is also released at the same time.)
(2) Release the hook by bending the arm of the cartridge stopper assy ( A ), slide the
cartridge stopper assy to the left ( B ) and the remove the cartridge stopper assy ( C ).
Rear
Scanner mount plate
Left side
Scanner mount plate
Scanner unit
Screws
Figure 4.8
Ground leaf spring
Cartridge stopper assy
Figure 4.9
Cartridge stopper assy
Figure 4.10
IV - 5
Screws
Beam
Right side
Screws
B
C
A
Front
Advertisement
Chapters
Troubleshooting
