Table of Contents
Advertisement
Clean Up
1.
Perform Pressure Relief Procedure,
page 11.
2.
Remove Guard and SwitchTip.
3.
Remove displacement pump from paint
and place in flushing fluid. Use water for
water-based paint and mineral spirits for
oil based paint.
4.
Turn motor switch ON. Turn hydraulic
pump valve ON. Turn prime valve
forward to SPRAY position.
3A4401A
ti8687a
ti9692a
ti29585a
5.
Hold gun against pail. Disengage trigger
lock. Turn pressure control up until motor
begins to drive pump. Trigger gun until
flushing fluid appears.
6.
Move gun to waste pail, hold gun against
pail, trigger gun to thoroughly flush
system. Release trigger and engage
trigger lock.
7.
While continuing to trigger gun, turn
prime valve down. Then release gun
trigger. Allow flushing fluid to circulate
until fluid comes out of drain tube clear.
Clean Up
PAINT
ti5272a
ti9694a
17
Advertisement
Table of Contents
