Clean The Spray Gun - Graco PRO AA5500SC Instructions And Parts List

Air-assisted airless spray gun

Hide thumbs Also See for PRO AA5500SC:

Table of Contents

Clean the Spray Gun

Equipment needed:

Soft bristle brush (supplied)

Solvent compatible with fluid being sprayed

Procedure:

1. Dip the end of a soft-bristle brush into a compatible

solvent. Clean the front of the gun with the brush

and solvent. See Fig. 17 .

NOTE: If it appears that there is paint inside the air

passages, remove the gun from the line for servic-

ing.

CAUTION

Avoid getting any solvent into the air passages.

Whenever possible, point the gun down while

cleaning it.

02007

Fig. 17

Maintenance

2. Dampen a soft cloth with solvent and wring-out the

excess. Wipe the exterior of the gun and shroud

clean. See Fig. 18 .

Fig. 18

3. Remove the bottom fluid tube fitting (P) and filter

(4). See Fig. 19 . Clean the filter in a compatible

solvent.

4. Reinstall the filter (4) and fitting (P). Do not over-

tighten the fitting (P) and make sure the top fluid

tube fitting (Q) remains tightened.

Fig. 19

Table of Contents