Table of Contents
Advertisement
Keep pump and hose clean when switching between simulated acoustic, knockdown and orange peel
applications. A dirty pump can release particles of texture into the finish.
•
Turn off sprayer if you are going to stop spraying for 5 minutes or longer.
•
Before removing material hose be sure pressure is relieved and material is not in hose.
•
To keep unit in good operating condition, always clean it thoroughly and prepare it properly for storage.
WARNING
Texture Spraying
Material Hopper
When you have finished spraying:
1. Open gun air valve.
2. Turn hopper gun/spray gun
selection switch to SPRAY
GUN.
3. Turn power switch ON.
4. Close gun air valve.
309796A
Shutdown and Cleanup
page 2, 5.
ti2448a
ti2456
ti2453
CAUTION
5. Trigger gun into bucket until most of texture mix is
pumped out.
6. Fill material hopper with 2-4 gallons of clean water.
7. Spray inside material
hopper to circulate water
through gun and hose.
While circulating water,
use gun to clean material
hopper.
8. Partially open gun air
valve to use air to
achieve better cleaning
results.
9. Spray water into a waste bucket to empty material
hopper.
A soft brush can be used to loosen dried on
material.
10. Turn power switch OFF.
11. Open gun air valve. Relieve Pressure, page 5.
ti2446a
CAUTION
If water freezes in unit damage may occur. In cold
weather store system where it will not freeze.
Shutdown and Cleanup
ti3160a
11
Advertisement
Table of Contents
