Table of Contents
Advertisement
Shutdown and Cleanup
Keep pump and hose clean when switching between simulated acoustic, knockdown and orange peel
applications. A dirty pump can release particles of texture into the finish.
•
To increase pump life, turn power off when not spraying.
•
Before removing material hose be sure pressure is relieved and material is not in hose.
•
To keep unit in good operating condition, always clean it thoroughly and prepare it properly for storage.
Texture Spraying (5 gallon Material Hopper)
When you have finished spraying:
1. Turn sprayer power switch (K) ON (air compressor
can remain OFF).
ti9202a
2. Close gun air valve.
ti8527a
3. Trigger gun into bucket until most of texture mix is
pumped out.
4. Fill material hopper with 2-4 gallons of clean water.
Shutdown and Cleanup
CAUTION
5. Spray inside material hopper to circulate water
through gun and hose. While circulating water, use
gun to clean material hopper.
6. Spray water into a waste bucket to empty material
hopper.
A soft brush can be used to loosen dried on
material.
7. Turn sprayer power switch OFF.
8. Turn air compressor ON.
9. Open gun air valve to blow out any remaining
texture residue. Flush with water.
CAUTION
If water freezes in unit, damage may occur. Store
system where it will not freeze during cold weather.
10. Turn air compressor OFF.
Inspect slots under machine daily for texture
material. If you find material flowing out of slots or
see material inside unit, replace pump hose
immediately.
ti8371a
11
Advertisement
Table of Contents
