Parameter Change During Operation - Siemens Simatic ET 200pro FC Operating Instructions Manual

Series commissioning and operation

8.4 Parameter change during operation

8.4 Parameter change during operation
Parameter change during operation
A frequency converter which is controlled via fieldbus also handles the transfer of
parameters via fieldbus in PROFIdrive mode using data set 47.
The transfer is described in the chapter entitled "Commissioning and Optimization":
● Parameter transfer to the frequency converter
● Parameter transfer from the converter
● Programming error.
See also
Block call (Page 109)
146
Operating Instructions, 07/2016, A5E01100763B AC
ET 200pro FC