Table of Contents
Advertisement
INTRODUCTION
REPLACING COMPONENTS:
•
Replacement of components shall be carried out using spare parts, or using parts approved
by Lennox.
•
Only the refrigerant shown on the manufacturer's nameplate shall be used.
PARAMETERING AND CONTROL:
•
For any intervention related to component parameterization, controls and unit operation
management, refer to Control manual.
FILTERS:
•
Do the filters fire classification's choice according to local regulations
TRANSPORT – HANDLING
•
Never lift the unit without forklift protections
•
Remove the forklift protection before installation
•
An approach ramp must be installed if the unit's installation requirements tell that it's
necessary to reach the main switch. This recommendation is valid for installations in general
and in particular for return and curbs. It's also valid to reach other parts of the unit: filters,
refrigerant circuit, etc...
•
It's advised to fix curbs and roofcurbs to the unit
•
Installation of the unit and accessibility must be compliant with the local regulations. Ensure
that all access equipment allow maintenance operation in safety (electrical cabinet, main
switch, panels, filter, refrigerant circuit...)
•
It is strictly forbidden to walk or store equipment or material on top of the rooftop unit
•
Equipment designed to withstand transport and handling according to the established
protocol (for the handling protocol, please refer to the installation instructions for the relevant
product range).
•
All unloading operations must be carried out with suitable equipment (crane, forklift truck,
etc.).
•
When using a forklift truck, you must respect the positions and the direction of handling
indicated on the products.
•
The equipment must be handled with care to avoid damage to the bodywork, pipework,
condenser, etc.
e-MovAir-IOM-20.04-EN
11
www.lennoxemea.com
Advertisement
Table of Contents
