Table of Contents
Advertisement
e-MovAir-IOM-20.04-EN
1.0. CHECKS BEFORE SHIPMENT
All of the e-MovAir series air handling units, before being sent, undergo a series of strict checks, as
listed below.
•
Dimensional checks to ensure that the actual dimensions of the unit comply with those
described in the constructional drawing undersigned by the customer.
•
Visual inspection of the finishes
•
Checks to ensure all the components are integral
•
Functional test on the electric motors and the humidification pumps
•
Visual check to ensure the fan impeller is balanced
•
Water seal test on the tanks
•
Gasket seal test
•
Locking of the dampers in the closing position
•
Securing of the coils (medium and large sizes only) for transport, to be released after
installation on site.
•
Securing of the fan vibration dampers (when considered necessary for the type of transport)
which must be released before starting.
•
Check to ensure the unit is supplied with all the materials for assembly on site (hardware,
silicon and so on). These materials, enclosed in a suitable packaging, are placed inside the
ventilating section as standard.
•
Application of the identification plates.
•
Application of the plates marking the discharges, water fittings, power connections, lifting
eyebolts.
Upon customer request, a special certificate can be issued relating to the above checks.
2.0. TRANSPORT
All the units are supplied without packaging. Only upon request, following quotation, packaging is
provided in cages, normal or special water- resistant crates, etc.
•
The components that, due to technical, constructional, transport or other requirements are
not fitted on the unit, but sent separately either inside the unit or otherwise, are specially
protected and duly described on the packing list.
•
All of the units are divided into constructional sections delivered disassembled; each section
can be transported by truck, with a maximum size of 2400 mm (W) x 2500 mm (H). Upon
specific customer request, larger units can be made for
oversized transport.
•
Special care is paid during the loading (truck or container)
operations. All the sections making up the units are handled
and stowed using special spacers to protect any protruding
parts, such as coil fittings, handles, hinges and so on.
•
Except where otherwise agreed in advance, no other
material must be stacked on the products: the manufacturer
declines all liability in the event of damage deriving from
such loads
THE FASTENING OF THE LOAD ON THE TRUCK IS THE RESPONSIBILITY OF THE CARRIER, AND
MUST BE PERFORMED, USING STRAPS OR ROPES, SO AS TO AVOID DAMAGING THE CASING.
UNDER NO CIRCUMSTANCES USE THE WATER FITTINGS OR THE DOOR HANDLES AS ANCHOR
POINTS.
e-MovAir-IOM-20.04-EN
Hinge door mechanism
14
www.lennoxemea.com
Advertisement
Table of Contents
