Table of Contents
Advertisement
e-MovAir-IOM-20.04-EN
3.0. UNLOADING
3.1. CHECKS UPON RECEIPT
When receiving the goods, before unloading, all the material delivered must be checked to ascertain
the presence of any damage caused during transport. Any damage found must be reported to the
carrier, accepting the goods with reservation and specifying the type of damage on the delivery
documents.
3.2. HOISTING AND HANDLING
The units are fitted as standard with a continuous
base frame support, with special holes to insert
lifting pipes for hoisting with cables.
Fork lift use is strictly forbidden for all e-MovAir
units, except for small sizes eM03AH025 +
eM04AH028 + eM05AH030 where additional
support feet are provided.
It is strongly recommended:
ATTACH THE CABLES AS SHOWN IN THE
FIGURE,
INSERTING
ADEQUATE
LENGTH
CABLES FROM DAMAGING THE CASING WHEN
TIGHTENED
•
Place the goods down with care, avoiding
sudden movements or, worse, dropping the
goods.
Where the support feet are fitted (sizes eM03AH025
+ eM04AH028 + eM05AH030 only), the units can
be handled by fork lift:
Caution:
•
Widen the forks as much as possible so as
to balance the load
•
Dip the ends of the forks to avoid damaging the bottom panels
WHEN HANDLING THE UNITS, USE SUITABLE MEANS ACCORDING THE WEIGHTS INVOLVED,
AS ENVISAGED BY EC DIRECTIVE 89/391 AND SUBSEQUENT AMENDMENTS
3.3. STORAGE
In the event of extended storage before installation, keep the units protected from dust and bad
weather and away from sources of vibrations and heat.
THE MANUFACTURER DECLINES ALL LIABILITY FOR DAMAGE DERIVING FROM INCORRECT
UNLOADING OR INADEQUATE PROTECTION OF THE UNITS AGAINST THE ELEMENTS.
4.0. UNIT IDENTIFICATION
The e-MovAir series air handling units feature a rating plate that describes the following:
•
Address of the manufacturer;
•
"CE" mark;
e-MovAir-IOM-20.04-EN
SPACERS
OF
AN
TO
PREVENT
THE
15
B
MAX 60º
B
www.lennoxemea.com
Advertisement
Table of Contents
