Table of Contents
Advertisement
INTRODUCTION
•
A flow protection device is not fitted.
•
The unit maintenance booklet is not complete or not available.
In these circumstances LENNOX is indemnified from any product liability claims from third parties.
In the event of a warranty claim the machine serial number and LENNOX order number must be
quoted.
NOTES FOR UNIT FITTED WITH GAS BURNER
THE UNIT MUST BE INSTALLED IN ACCORDANCE WITH LOCAL SAFETY CODES AND
REGULATIONS AND CAN ONLY BE USED IN WELL VENTILATED AREA.
IF MACHINE IS INCLUDING GAS BURNER, MINIMUM CLEARANCE AROUND THE UNIT MUST BE
AT LEAST 8M TO ALLOW A PROPER GAS FLUE DILUTION. IF NOT POSSIBLE, THE FRESH AIR
INTAKE MUST BE DUCTED AT LEAST 8M AWAY FROM THE GAS BURNER EXHAUST.
PLEASE READ CAREFULLY THE MANUFACTURER'S INSTRUCTIONS BEFORE STARTING THIS
UNIT
Switchgear must be installed on each unit in accordance with the Machine Directive and the
standard EN 60204.
THIS MANUAL IS ONLY VALID FOR UNITS DISPLAYING THE FOLLOWING CODES:
In case these symbols are not displayed on the unit, please refer to the technical documentation
which will eventually detail any modifications required to the installation of the unit in a particular
country.
All the technical and technological information contained in this manual, including any drawing and
technical descriptions provided by us, remain the property of Lennox and must not be used (except
in operation of this product), reproduced, issued to or made available to third parts without the prior
written agreement of Lennox.
The technical information and specifications contained in this manual are for reference only. The
manufacturer reserves the right to modify these without warning and without obligation to modify
equipment already sold
SAFETY
The safety information contained in this manual is provided as a guide for the safe handling of this
installation. LENNOX does not vouch for the completeness of this information and can therefore not
accept liability for any possible omissions. In the roof tops, heat is being transported by a pressurized
refrigerant, with changes in pressure and temperature. For air cooled roof tops, fans have been provided
to discharge heat into the environment. The protection of operating and maintenance personnel was
central in the design of the roof top. Safety features have been included to prevent excessive pressure
in the system. Sheet metal parts have been fitted to prevent inadvertent contact with (hot) pipes. For
air cooled roof tops, the fans are equipped with protective grids and the electrical control panel is
completely touch-proof. This excludes some parts operating at a safe voltage (< 24 Volt). The service
panels can only be opened using tools.
The electrical control panel is completely touch-proof. This excludes some parts operating at a safe
voltage (< 50 Volt). The service panels can only be opened using tools.
e-MovAir-IOM-20.04-EN
GB IR GR DA NO FI IS
5
www.lennoxemea.com
Advertisement
Table of Contents
