Table of Contents
Advertisement
1
Introduction
Switch off all affected devices (computer, printer, accessories) before connecting or disconnecting.
•
•
In operation, moving parts are easily accessible.
This applies especially for the zone, where the pad is moved between the starting and the labelling position.
During operation do not reach into that zone and keep long hair, loose clothes, and jewelry away. Before any
alterations are undertaken in those areas, close the compressed air shutoff valve.
•
The device may only be used in a dry environment, do not expose it to moisture (water splashes, sprays and mist)
•
Do not use the device in an explosive atmosphere.
•
Do not use the device close to high-voltage power lines.
•
Perform only those actions described in this service manual.
Work going beyond this may only be performed by trained personnel or service technicians.
•
Unauthorized interference with electronic modules or their software can cause malfunctions.
Other unauthorized work on, or modifications to the device can also endanger operational safety.
•
Always have service work done by a qualified workshop, where the personnel have the technical knowledge and
•
tools required to do the necessary work.
•
There are various warning stickers on the device. They draw your attention to danger. Warning stickers may
therefore not be removed.
1.4
Safety Marking
Fig. 1
Safety marking
1.5
Environment
Obsolete devices contain valuable recyclable materials that should be sent for recycling.
Send to suitable collection points, separately from residual waste.
The modular construction of the print module enables it to be easily disassembled into its component parts.
Send the parts for recycling.
1:
2:
1
3:
Attention!
!
Never remove or cover safety markings!
2
Replace it in case of damage!
3
Warning to damages by moving
parts!
The cylinder is under pressure
also if the printer is switched off.
Possibility of residual energy!
Danger of crushing to hands and
fingers by the moving pad!
5
Advertisement
Table of Contents
