5
Installation
5.1
Factory default Settings
i
Note!
The applicator is set up in a standard configuration by the factory. These values guarantee a smooth
operation.
i
Note!
In the case of a customer specific setup with special material the settings can deviate from the standard
values.
In this case the standard values in the setup protocol are as follows.
The factory default settings are:
•
Connected to a cab Hermes+ printer, vertical
•
Used Pad:
•
Material used for factory default settings:
•
Pressure value of the compressed air:
•
Factory setting sensors
Cylinder Z „6.8 Lift Speed of Cylinder Z"
Cylinder X/Y „6.13 Sensors on Cylinder X/Y"
•
Factory settings throttle valves
Cylinder Z „6.8 Lift Speed of Cylinder Z"
Cylinder X/Y „6.12 Lift Speed of Cylinder X/Y"
5.2
Tools
Screwdriver with parallel blade
Hexagon key L-wrench
Flat-round nose
Open spanner
Manometer
cab part No.: 5963881 54x36 for L
cab part No.: 5963878 54x36 for R
cab part No.: 5556472 54x35.5
0.45 MPa (4.5 bar)
2.5
0.8
2.5
4
straight
angled
SW 8
SW 13
SW20
± 7 bar
•
To adjust the throttle valves
and product sensor
•
To adjust the sensors
(in contents of delivery)
•
For matched norm parts
(in contents of delivery)
•
Pad adjustments
Changing pad
•
To mount/dismount tubes
•
To change the throttle valves
•
Setting the spring strength of
the adapter bolt
•
Changing the cylinder
•
Air pressure control
13