Setting The Peel Position; Activation Of Peel-Off Mode - CAB 4414 Series Service Manual

7 Configuration
7.3

Setting the Peel Position

To optimize the transfer of the labels from the printer to the pad there are two different parameters available for
adjusting the peel position.
!
Attention!
 First adjust the parameter "Peel Position" in the printer configuration.
 Then adjust the additional peel-off offset in the software.
It is very important to follow that procedure for a certain start after label loading and for the re-start after
error treatment.
Parameter "Peel Position" in the printer configuration
 Check the basic settings in the printer setup. Perform labelling cycles by alternately pressing the
and Enter button
 In the submenu
labels are peeled-off completely from the liner
 „7.3 Configuration Parameters of the Applicator"
Peel-off offset in the software
 Check the setting in the software. Perform labelling cycles by repeatedly pressing the Enter button
 „8.2 Test Mode with a Print Job"
 Adjust the peel-off offset in such a way, that the printed labels are peeled-off completely from the liner
 Programming manual or software documentation.
Activation of Peel-off Mode
7.4
i
Note!
 For labelling operation activate the peel-off mode in the software.
 For direct programming use the P command  Programming manual.
.  „8.1 Test Mode without a Print Job"
Labelling > Peel-off position adjust the "Peel-off position" in such a way, that the blank
33
button
.