6
Adjustments
30
6.14
Labeling from Below - Changing the Spring of the Impact Sensor
For fault free labeling in a side- or upward-motion it is necessary to change the spring of the impact sensor.
The stronger spring prevents the unwanted triggering of the impact sensor due to the inertia of the cylinder and stamp
assembly group.
1
2
Fig. 35
Demounting the stamp
3
4
5
6
Fig. 36
Loosening the adapter bolt
3
7
4
Fig. 37
Changing the spring
Loosen screw (1) and dismount the stamp (2) to get to the locking
washer (6).
Push the adapter bolt (3) into the stamp uptake (4) to ensure that the
bottom of the bolt is pushed out.
Demount locking plate (6).
Remove washer (5).
Hold onto the adapter bolt (3) and pull off the stamp uptake (4).
Pull out the pressure spring (6) and replace it with the alternative.
Push together the stamp uptake (4) and the adapter bolt (3).
Replace the washer (5).
Place the locking washer (6) back into it's position.
30