5
Installation
14
5.3
Mount and dismount the cover
To initiate the applicator or for adjustments it is necessary to dismount the cover (2).
After these adjustments have been completed remount the cover.
Warning!
!
Do not operate the applicator without the cover (2).
Dismount the cover only for service and/or adjustment purposes.
Fig. 8
Cover
5.4
Transportation Lock
Fig. 9
Stopper as transport lock
When the applicator is delivered, the stopper (2) is mounted on the rod (1). With this stopper (2) the labelling position
for the operation mode "Blow on" can be adjusted.
In transit the stopper (2) is used as a transport lock.
i
Note!
To reduce the impact energy it is possible to use a stopper with cushion (4).
Releasing the transport lock
1. Loosen screw (3) of the stopper (2).
2. Move the stopper (2) along the rod (1) into the position as in operation mode:
Operation mode "Blow on": 7.4 Adjusting the stopper
•
•
Operation mode "Stamp on" : Move the stopper (2) up to the end of the rod (1).
3. Tighten screw (3) to fix the stopper (2) in position.
1
2
3
1
2
3
1. Loosen screw (3).
2. Lift cover (2) upwards.
3. Move the cover (2) from top over the cylinder
assembly.
4. Put in the cylinder (1) into the hole in the cover
(2) .
5. Tighten screw (3) to fix cover (2) .
2
3
1
14
3
4