Table of Contents
Advertisement
Adjusting the GUIDE SHOES on the DEVELOPER RACK
Important
Before doing this procedure, do the procedures listed below:
• Adjusting the Squareness of the DEVELOPER RACK on
• Adjusting the Tension on the DRIVE CHAIN on
Warning
Dangerous voltage.
[1] De-energize the PROCESSOR.
Note
To prevent the contamination of the processing solutions, use the RACK SPLASH GUARD and DRIP TRAY when
you remove the RACK from the PROCESSOR.
CLUSTER
ROLLER
SHAFT
H150_0171BCA
H150_0171BA
[2] Remove the DEVELOPER RACK from the PROCESSOR.
[3] Remove the SPRING from each end of the TURNAROUND section of the DEVELOPER RACK.
[4] Remove the following parts from the drive end of the MASTER ROLLER SHAFT:
• SCREW
• LOCKING PLATE
• WASHER
[5] Install the SCREW and WASHER removed in the previous step to hold the MASTER ROLLER SHAFT in
position.
[6] While holding the SCREW that secures the drive end of one of the CLUSTER ROLLERS, rotate the SCREW
that secures the non-drive side of the CLUSTER ROLLER.
[7] Remove the following parts from either end of the CLUSTER ROLLER.
• SCREW
• 2 WASHERS
• SPACER
[8] Pull the CLUSTER ROLLER SHAFT out through the SIDEPLATE of the DEVELOPER RACK.
[9] Remove the CLUSTER ROLLER from the DEVELOPER RACK.
[10] Repeat
Step 6
through
7C8285 – 28JAN98
Page
drive side
WASHER
Step 9
for the second CLUSTER ROLLER.
Page
8.
17.
MASTER ROLLER
SHAFT
SPACER
WASHER
SCREW
ROLLER TRANSPORT
SPRING
WASHER
PLATE
SCREW
9
Advertisement
Table of Contents
