Adjusting The Developer Or Fixer Rack Drive Chain - Kodak X-Omat 3000 RA Manual

Adjusting the DEVELOPER or FIXER RACK DRIVE CHAIN

Note
To prevent the contamination of the processing solutions, use the RACK SPLASH GUARD and DRIP TRAY when
you remove the RACK from the PROCESSOR.
[1] Remove the DEVELOPER or FIXER RACK.
non-drive
side
equal
distance
H150_0169BCA
H150_0169BA
[2] Loosen the 2 HOLDING SCREWS at each end of the RACK approximately 1 full turn.
[3] Hold the RACK vertically above the work surface and allow gravity to provide full tension on the TURNAROUND.
[4] If necessary, turn the 2 ADJUSTING SCREWS on the drive end of the RACK counterclockwise until the
SCREWS do not contact the TURNAROUND SIDEPLATE.
[5] Rotate the DRIVE GEAR 6 full turns.
[6] Tighten the 2 HOLDING SCREWS on the drive end of the RACK.
[7] Place the RACK vertically on a flat work surface.
[8] Rotate the 2 ADJUSTING SCREWS on the drive end of the RACK clockwise until both SCREWS just touch the
TURNAROUND SIDEPLATE on the drive end of the RACK.
[9] Loosen the 2 HOLDING SCREWS on the drive end of the RACK approximately 1 full turn.
[10] Rotate the 2 ADJUSTING SCREWS on the drive end of the RACK counterclockwise 1 full turn.
[11] Tighten the 2 HOLDING SCREWS on the drive end of the RACK.
[12] Using a THICKNESS GAUGE TL-2372 measure the distance between the UPPER SIDEPLATE and the
TURNAROUND SIDEPLATE on the drive end of the RACK.
[13] Rotate the 2 ADJUSTING SCREWS on the non-drive end of the RACK until the distance between the UPPER
SIDEPLATE and the TURNAROUND SIDEPLATE is the same as the distance between the 2 SIDEPLATES on
the drive end of the RACK.
[14] Tighten the 2 HOLDING SCREWS on the non-drive end of the RACK.
[15] Assemble the PROCESSOR and check that it operates correctly.
7C8285 – 28JAN98
non-
drive
side
drive side
equal
distance
THICKNESS
GAUGE
TL2372
drive
side
TURNAROUND
SIDEPLATE
ROLLER TRANSPORT
UPPER
SIDEPLATE
4 ADJUSTING
SCREWS
THICKNESS
GAUGE
TL2372
4 HOLDING
SCREWS
TURNAROUND
13