Table of Contents
Advertisement
2 SAFETY ADVICE
2.14
Unless specified otherwise, the ignition must be turned off during all work (models with ignition lock, models
with remote key) or the engine must be at a standstill (models without ignition lock or remote key).
Special tools are necessary for certain tasks. The tools are not a component of the vehicle, but can be ordered
using the number in parentheses. Example: bearing puller (15112017000)
During assembly, use new parts to replace parts which cannot be reused (e.g. self-locking screws and nuts,
expansion screws, seals, sealing rings, O-rings, pins, and lock washers).
In the case of certain screws, a screw adhesive (e.g. Loctite
tions.
If thread locker (e.g., Precote
locker.
After disassembly, clean the parts that are to be reused and check them for damage and wear. Change dam-
aged or worn parts.
After completing a repair or service work, check the operating safety of the vehicle.
2.15
If you use your motorcycle responsibly, you can ensure that problems and conflicts do not occur. To protect
the future of the motorcycle sport, make sure that you use your motorcycle legally, be environmentally aware,
and respect the rights of others.
When disposing of used oil, other operating and auxiliary fluids, used components, and, if applicable, the end-
of-life motorcycle, comply with the respective laws and regulations of the respective country.
24
Work rules
®
) has already been applied to a new part, do not apply any additional thread
Environment
®
) is required. Observe the manufacturer's instruc-
Advertisement
Table of Contents
