Husqvarna SVARTPILEN 401 Owner's Manual page 162

12 SERVICE WORK ON THE CHASSIS
160
–
Check the chain sliding guard for wear.
» C
If in area
ble from above:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
–
Tighten the screw of the chain sliding guard.
Guideline
F02685-10
Screw, chain slid-
ing guard
Finishing work
–
Remove the rear of the motorcycle from the lifting gear.
( p. 126)
by the chain sliding guard screw
M6 9 Nm (6.6 lbf ft)
1
is visi-