Table of Contents
Advertisement
15.8
Checking the headlight setting
Guideline
Insert holding lug
–
Insert the screw and first turn counterclockwise until it
engages in the thread with a small jerk. Tighten the screw
lightly.
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a marking at the height of the center of
the low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle perpendicular to the wall at a
A
distance
400726-10
Guideline
A
Distance
–
The rider now mounts the motorcycle with luggage and pas-
senger if applicable.
–
Check the headlight setting.
ELECTRICAL SYSTEM 15
A
B
into cut-out
.
B
under the first marking.
5 cm (2 in)
from the wall and switch on the low beam.
5 m (16 ft)
213
Advertisement
Table of Contents
