Changing The Turn Signal Bulb - Husqvarna SVARTPILEN 401 Owner's Manual

15 ELECTRICAL SYSTEM
15.7
Note
Damage to reflector Grease on the reflector reduces the light intensity.
Grease on the bulb will evaporate due to the heat and be deposited on the reflector.
–
Clean and degrease the bulbs before mounting.
–
Do not touch the bulbs with your bare hands.
212

Changing the turn signal bulb

K00017-10
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove turn signal glass
–
2
Press bulb carefully into the socket, turn it counterclock-
wise by about 30°, and take it out of the socket.
Guideline
Do not touch the reflector with your fingers and keep it free
from grease.
–
Push the new bulb gently into the socket and turn it clock-
wise all the way in.
Turn signal (RY10W / socket BAU15s) (
–
Check that the turn signal is functioning properly.
–
Position the turn signal glass.
1
.
p. 264)