Installer's Programming Commands; Installer Code Functions - Bosch Solution 6+6 Quick Reference Manual

Page 6

Installer's Programming Commands

There are several commands that can be invoked to perform the functions as listed below. These commands
only operate while you are in the Installer's Programming Mode. To invoke the command, enter in the
corresponding numerical code then press the
Command
958 Enable and Disable Zone Status Mode When Using The Hand Held Programmer
959 Test Programming Key
960 Exit Installer's Programming Mode
961 Reset To Factory Default Settings (Contact ID Format)
962 Copy The Panel Memory To The Programming Key
963 Copy The Programming Key Data To The Panel Memory
964 Wipe Programming Key
965 Set Defaults For Domestic Dialling Reporting Format
966 Enable and Disable Automatic Stepping Of Locations During Programming
999 This Command Displays The Control Panel's "Software Version" Number When
Using The Hand Held Programmer

Installer Code Functions

Installer Code functions are designed to allow the installer to perform various system tests without the need to
know a Master Code.
The is entered followed by a
function.
These functions can only be carried out while the system is in the disarmed state.
Function
0 Fault Analysis Mode
1 Reserved
2 Set Number Of Days Until The First Test Report
3 Event Memory Recall
4 Walk Test Mode
5 BOSCHSAT - Satellite Siren Service Mode
6 Initiate Modem Call
7 Turning Telephone Monitor Mode On and Off
8 Reserved
Send A Test Report
9
How To Enter Fault Analysis Mode
1. Enter your
One or more zone indicators will illuminate to indicate the type of fault that has occurred.
2. Press the button to exit this function.
How To Set the Number Of Days Until The First Test Report
1. Enter your
2. Enter the
SOL 6+6 QUICK REF GUIDE.DOC
button.
Table 3: Installers Programming Commands
+
Table 4: Installer Code Functions
0
followed by and the
2
followed by and the
(01 – 99) until the first test report followed by the
Bosch Security Systems Pty Limited
Solution 6+6
Description
digit then the button to activate the particular
+
Description
button.
button.
Quick Reference Guide
button.