Installer's Programming Commands; Installer Code Functions - Bosch Solution 6+6 Wireless AE Quick Reference Manual

Solution 6+6 Wireless - AE

Installer's Programming Commands

There are several commands that can be invoked to perform the functions as listed below. These commands only operate
when you have accessed the Installers Programming Mode. To invoke the command required, enter the corresponding
numerical code followed by the
Command
958
959
960
961
962
963
964
965
966
999

Installer Code Functions

Installer Code Functions are designed to allow the installer to perform various system tests without the need to know a
Master Code.
The is entered followed by a
These functions can only be carried out when the control panel is disarmed.
Function
0
1
2
3
4
5
6
7
8
9
Page 6
Quick Reference Guide
button.
Enable and Disable Zone Status Mode
Test Programming Key
Exit Installer's Programming Mode
Set Defaults For Contact ID Format (Factory Default Settings)
Copy The Panel Memory To The Programming Key
Copy The Programming Key Data To The Panel Memory
Erase Programming Key
Set Up Domestic Dialling Format
Enable and Disable Automatic Stepping Of Locations During Programming
This Command Displays The Control Panel's "Software Version" Number Using The Hand
Held Programmer
Installers Programming Commands
digit then the
+
Fault Analysis Mode
Enable/Disable Wireless Zones
Set Number Of Days Until The First Test Report
Event Memory Recall Mode
Walk Test Mode
Satellite Siren Service Mode
Initiate A Modem Call
Turning Telephone Monitor Mode On and Off
Reserved
Send A Test Report
Installer Code Functions
Bosch Security Systems Pty Limited
Function
button to enter you into a particular mode.
+
Description
ISSUE 1.00