Bosch Solution 6+6 Quick Reference Manual page 4

Page 4
Programming Using The Remote Codepad
The system must be in the disarmed state with no flashing zone alarm memories, this can be achieved by
entering the followed by the
To access the Installer's Programming Mode, enter the four digit
The factory default Installer Code is
indicators will flash simultaneously. If a long beep is heard, check the system for alarm memory. The codepad
indicators will display the current data stored in the first location (LOCATION 000).
Data Zone 1 Zone 2
Value Indicator Indicator
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Example
To enter Installer's Programming Mode, enter the
will be heard and the codepad will display the current data stored in "LOCATION 000".
To move to a particular programming location, enter the
button. The data of the new location will now be displayed.
To move to the next location, press the
location will be displayed via the
If you press the button without previously entering a location number, the system will step back one
location. To change data in the current location, enter the new value (0 – 15) followed by the
This will store the new data into the location and still leave you positioned at the same location.
To proceed to the next location, press the
To exit the Installer's Programming Mode, enter command
will be heard and the system will return to the disarmed state.
For a more detailed explanation, refer to the
SOL 6+6 QUICK REF GUIDE.DOC
button. The factory default Master Code is
1234
. Three beeps will be heard and both the
Zone 3 Zone 4 Zone 5
Indicator Indicator Indicator
Table 1: Zone Indicators When Programming
button. This will step you to the next location and the data in that
ZONE indicators.
button. The next locations data will now be displayed.
960
(MA600I).
Bosch Security Systems Pty Limited
Solution 6+6
followed by the
Zone 6 Zone 7
Indicator Indicator Indicator
followed by the
required followed by the
followed by the
Installation Manual
Solution 6+6
Quick Reference Guide
2580
.
button.
and the
AWAY STAY
Zone 8 MAINS
Indicator
button. Three beeps
button.
button. Two beeps