Setting Your Changes As New Default; Restoring All The Settings To Factory Settings; Scan To Card; Entering Scan Mode - Brother MFC-820CW User Manual

Chapter 12
Setting your changes as new
default
You can save the print settings you use most
often by setting them the default settings.
These settings will stay until you change
them again.
a
Press a or b to choose your new
setting.
Press OK.
Repeat this step for each setting you
want to change.
b
After changing the last setting, press a
or b to choose Set New Default.
Press OK.
c
Press 1 to choose Yes.
d
Press Stop/Exit.
Restoring all the settings to
factory settings
You can restore all the settings you have
changed to the factory settings. These
settings will stay until you change them again.
a
Press (PhotoCapture).
b
Press a or b to choose
Factory Reset.
Press OK.
c
Press 1 to choose Yes.
d
Press Stop/Exit.
84

Scan to Card

12

Entering Scan mode

When you want to scan to card, press
(Scan) to illuminate it in green.
The LCD shows:
SCAN
Scan to E-mail
Scan to Image
Scan to OCR
Scan to File
Scan to Card
12
Select & Press
If you are not connected to your computer
only the Scan to Card selection will
appear on the LCD.
Press a or b to scroll through the Scan key
options.
Scan to E-mail (See Software User's
Guide.)
Scan to Image (See Software User's
Guide.)
Scan to OCR (See Software User's
Guide.)
Scan to File (See Software User's
Guide.)
Scan to Card (See page 85.)
When the option you want is highlighted,
press OK.
12
12
OK