Mode Timer; Setting The Mode Timer; Paper Settings; Setting The Paper Type - Brother MFC-820CW User Manual

Mode Timer

Setting the Mode Timer

The machine has four temporary mode keys
on the control panel: PhotoCapture, Copy,
Fax and Scan. You can change the amount of
time the machine takes after the last Copy,
Scan or PhotoCapture operation before it
returns to Fax mode. If you choose Off, the
machine stays in the mode you used last.
a
Press Menu.
b
Press a or b to choose
General Setup.
Press OK.
c
Press a or b to choose Mode Timer.
Press OK.
d
Press a or b to choose 0 Sec,
30 Secs, 1 Min, 2 Mins, 5 Mins or
Off.
Press OK.
e
Press Stop/Exit.

Paper settings

3

Setting the Paper Type

3
To get the best print quality, set the machine
for the type of paper you are using.
a
Press Menu.
b
Press a or b to choose
General Setup.
Press OK.
c
Press a or b to choose Paper Type.
Press OK.
d
Press a or b to choose Plain,
Inkjet, Glossy or Transparency.
Press OK.
e
Press Stop/Exit.
Note
The machine ejects paper with printed
surfaces face up onto the paper tray in
front of the machine. When you use
transparencies or glossy paper, remove
each sheet at once to prevent smudging
or paper jams.

Setting the Paper Size

You can use five sizes of paper for printing
copies: Letter, Legal, A4, A5, and 4 × 6 in.
(10 × 15 cm) and three sizes for printing
faxes: Letter, Legal and A4. When you
change the size of paper you load in the
machine, you will need to change the paper
size setting at the same time so your machine
can fit an incoming fax on the page.
a
Press Menu.
b
Press a or b to choose
General Setup.
Press OK.
c
Press a or b to choose Paper Size.
Press OK.
General setup
3
3
3
3
21