Setting Your Changes As The New Default; Restoring All Settings To The Factory Settings - Brother DCP-395CN User Manual

Using a scanned paper document as
your watermark
a
Enter the number of copies you want.
b
Press a or b to choose
Watermark Copy.
Press OK.
c
Press d or c to choose On.
d
Press a or b to choose
Current Setting.
Press OK.
e
Press a or b to choose Scan. Press OK.
Then set the page that you want to use
as a watermark on the scanner glass.
f
Press Black Start or Color Start.
g
Take out the watermark document you
scanned and load the document you
want to copy.
h
Press d or c to change the
Transparency of the watermark.
Press OK.
i
Press Black Start or Color Start.
Note
You cannot enlarge or reduce the
scanned watermark.
Downloaded from ManualsPrinter.com Manuals
Setting your changes as the
new default
4
You can save the copy settings for Quality,
Enlarge/Reduce, Brightness,
Contrast, Ink Save Mode and
Page Layout that you use most often by
setting them as the default settings. These
settings will stay until you change them again.
a
Press a or b to choose your new setting.
Press OK.
Repeat this step for each setting you
want to change.
b
After changing the last setting, press
a or b to choose Set New Default.
Press OK.
c
Press + to choose Yes.
d
Press Stop/Exit.
Restoring all settings to the
factory settings
You can restore all the settings you have
changed back to the factory settings. These
settings will stay until you change them again.
a
Press a or b to choose
Factory Reset.
Press OK.
b
Press + to choose Yes.
c
Press Stop/Exit.
Making copies
4
4
4
35