2Tap Pan Dly (2 Tap Pan Delay); Fuzz; Juno-106 Chorus; Exciter - Roland Aerophone Pro Parameter Manual

Hide thumbs Also See for Aerophone Pro:
Table of Contents

Advertisement

75 2Tap Pan Dly
L in
Delay 1
Double Tap
Double Tap
Delay
Delay
Feedback
Delay 2
R in
Parameter
Value
Delay Time
OFF, ON
(sync sw)
Delay Time (msec) 1–2600 (msec)
Note
Delay Time (note)
&
"Note"
(p. 64)
Feedback
-98–+98 (%)
200, 250, 315, 400,
500, 630, 800, 1000,
1250, 1600, 2000,
HF Damp
2500, 3150, 4000,
5000, 6300, 8000,
BYPASS (Hz)
Delay 1 Pan
L64–63R
Delay 2 Pan
L64–63R
Delay 1 Level
0–127
Delay 2 Level
0–127
Low Gain
-15–+15 (dB)
High Gain
-15–+15 (dB)
Balance
D100:0W–D0:100W
Level
0–127

86 Fuzz

Adds overtones and intensely distorts the sound.
L in
Pre Filter
Pre Filter
Overdrive
Overdrive
R in
Pre Filter
Pre Filter
Overdrive
Overdrive
Parameter
Value
Drive
0–127
Tone
0–100
Level
0–127
(2 Tap Pan Delay)
Balance D
Balance W
Balance W
Balance D
Explanation
If this is ON, the delay synchronizes with
the tempo.
Adjusts the delay time from the direct
sound until the second delay sound is
heard.
Adjusts the proportion of the delay sound
that is fed back into the effect. Negative
(-) settings will invert the phase.
Adjusts the frequency above which the
delay sound fed back to the effect is
filtered out
(BYPASS:
no cut).
Stereo location of Delay 1
Stereo location of Delay 2
Volume of delay 1
Volume of delay 2
Gain of the low range
Gain of the high range
Adjusts the volume balance between the
sound that is sent through the delay (W)
and the sound that is not sent through
the delay (D).
Output Level
Tone
Tone
L out
Post Filter
Post Filter
Control
Control
Tone
Tone
Post Filter
Post Filter
R out
Control
Control
Explanation
Adjusts the amount of distortion.
This also changes the volume.
Sound quality of the Overdrive effect
Output Level

87 JUNO-106 Chorus

This models the chorus effects of the Roland JUNO-106.
L out
L in
R in
Generator
Generator
R out
Parameter
Mode
Noise Level
Balance
Level

92 Exciter

This adds dynamics to the sound, by dynamically bringing up the
high end using a split-band compressor.
* This effect can be used as an IFX. The effect is not available for the
MFX.
L in
Channel
Divider
R in
Channel
Divider
Parameter
Band2 Threshold
Band2 Max Gain
Band3 Threshold
Band3 Max Gain
Split1 Frequency
Split2 Frequency
Level
MFX/IFX Parameters
Chorus
Chorus
Noise
Noise
Value
Explanation
Type of Chorus
I, II, I+II, JX I, JX II
I+II:
The state in which two buttons are
pressed simultaneously.
0–127
Volume of the noise produced by chorus
Volume balance between the dry sound
D100:0W–D0:100W
(D) and effect sound (W)
0–127
Output Level
Low
Mid
Compressor
High
Compressor
Low
Mid
Compressor
High
Compressor
Value
Explanation
Raises the midrange frequency levels
-80.0–0.0 (dB)
when they fall below the specified
amount.
Sets how much to raise the levels when
0–+24 (dB)
the midrange volume is low.
Raises the high-end frequency levels
-80.0–0.0 (dB)
when they fall below the specified
amount.
Sets how much to raise the levels when
0–+24 (dB)
the high-end frequency volume is low.
Frequency at which the low and
2000–5000 (Hz)
midrange frequencies are split
Frequency at which the midrange and
3000–10000 (Hz)
high-end frequencies are split
0–127
Output Level
L out
R out
L out
R out
63

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ae-30Aerophone pro ae-30

Table of Contents