Roland Aerophone Pro Parameter Manual page 6

Settings Used on this Instrument
Value
Indication (Parameter)
Sets the pitch of the harmony notes that work when each controller function is set to "Harmony. "
Up to four harmony notes can be added.
Harmony 1
* This is enabled when the Harmony Source is "System. "
Harmony 2
Oct below (-12), 7th Maj below (-11), 7th min below (-10), 6th Maj below (-9), 6th min below (-8), 5th below (-7),
Harmony 3
Tritone below (-6), 4th below (-5), 3rd Maj below (-4), 3rd min below (-3), 2nd Maj below (-2), 2nd min below (-1),
Harmony 4
Off,
2nd min above (+1), 2nd Maj above (+2), 3rd min above (+3), 3rd Maj above (+4), 4th above (+5), Tritone above (+6),
5th above (+7), 6th min above (+8), 6th Maj above (+9), 7th min above (+10), 7th Maj above (+11), Oct above (+12)
These parameters select whether to use the system settings or the scene settings for tone control.
Ctrl Source Select
System
Scene
System Ctrl Source 1
System Ctrl Source 2
Off, CC01–31, CC33–95,
Bend, After Touch
System Ctrl Source 3
System Ctrl Source 4
Sets the function of the [CATEGORY] knob.
Category
Category Knob Mode
User
Favorite
Scene Shortcut
Off, On
Edit Confirm
Off, On
Bluetooth
Off, On
Bluetooth ID
Off, 1–9
6
Explanation
Uses System Control Source 1–4.
Uses Control Source 1–4 for the scene.
Sets the MIDI messages to use for tone control.
This lets you select a preset scene category by turning the knob.
Hold down the [=] button and turn the knob to select a favorite scene.
Hold down the [?] button and turn the knob to select a user scene bank.
This lets you select a user scene bank by turning the knob.
Hold down the [=] button and turn the knob to select a preset scene category.
Hold down the [?] button and turn the knob to select a scene that's registered as a
favorite.
This lets you select a scene registered as a favorite by turning the knob.
Hold down the [=] button and turn the knob to select a preset scene category.
Hold down the [?] button and turn the knob to select a user scene bank.
This turns the shortcut function on/off, which is useful for switching between scenes.
= ?
[SCENE] ( / ) button
Holding down the
[SCENE] (=) or (?)
button
Sets whether to show a confirmation message (On) or not (Off ) when a scene parameter is
edited and you select a different scene without saving your user scene.
Turns the Bluetooth function on/off.
If you are pairing with your smartphone in a location where there are multiple Aerophone Pro
units, you can assign an ID to each unit. When you specify a Device ID, the specified number is
added to the end of the device name that is shown on app "Aerophone Pro Editor. "
(Example: "AE-30 AUDIO 1", "AE-30 1", etc.)
4
5
6
1
7
2
8
3
Scene number –1
Scene number +1
1 8
Select the user scene (U01-01–U01-08)
–
Eb Scene number –1
C
Scene number +1