Tone/Partial/Partial Eq; Tone/Partial/Output; Tone/Partial/Control - Roland Aerophone Pro Parameter Manual

TONE/PARTIAL/PARTIAL EQ

Parameter Value
Switch OFF, ON
Low Gain -24.0–+24.0 (dB)
Low Frequency 20–16000 (Hz)
Mid Gain -24.0–+24.0 (dB)
Mid Frequency 20–16000 (Hz)
Mid Q 0.5–16.0 (0.1step)
High Gain
-24.0–+24.0 (dB)
High Frequency
20–16000 (Hz)

TONE/PARTIAL/OUTPUT

Parameter Value
Output Assign DRY, MFX
Chorus Send Level 0–127
Reverb Send Level 0–127
Explanation
Turns the equalizer on/off for each partial.
Gain of the low range.
Frequency of the low range.
Gain of the middle range.
Frequency of the middle range.
Width of the middle range.
Set a higher value to narrow the range to
be affected.
Gain of the high range
Frequency of the high range.
Explanation
Specifies how the sound of each partial
will be output.
Specifies the level of the signal sent to the
chorus for each partial.
Specifies the level of the signal sent to the
reverb for each partial.

TONE/PARTIAL/CONTROL

Parameter Value
ADSR Envelope
OFF, ON
Switch
Specifies the envelope mode.
NO-SUS
Envelope Mode
SUSTAIN
Damper Free Note OFF, 1–127
D.Free Decay
-100–+100
Offset
Receive Bender OFF, ON
Receive
OFF, ON
Expression
Receive Hold-1 OFF, ON
Redamper Switch OFF, ON
Soft EQ Sens
0–100
Wave Tempo Sync
OFF, ON
Tone Parameters
Explanation
This imitates the operation of the ADSR
envelope that is provided on an analog
synthesizer.
* If ADSR Envelope Switch is "ON, "
the "Time 2" parameters of Pitch/
Filter/Amp Env Time respectively
are ignored, and only the "Level 3"
parameters of Pitch/Filter/Amp Env
Level are valid.
The envelope transitions to the release
segment after passing Time 3 regardless
of the note-off timing, operating
according to the times specified by the
envelope.
The Envelope Level 3 is held from when
the envelope Time 3 has elapsed until
note-off.
When note-off occurs, the envelope
transitions from the current value to the
Time 4 segment (release segment).
For notes above the specified note
number, the Envelope Mode operates as
"NO-SUS. "
Use this to simulate the undamped
region of a piano sound.
Specifies a fine adjustment to the time
over which the sound decays when the
Damper Free Note effect is applied.
Specifies for each partial whether MIDI
pitch bend messages are received (ON)
or not received (OFF).
Specifies for each partial whether MIDI
expression messages are received (ON)
or not received (OFF).
Specifies for each partial whether MIDI
hold 1 messages are received (ON) or not
received (OFF).
If Redamper Switch is ON, you can
perform the Half Damper operations
used for piano sounds.
However, the following conditions
must be satisfied in order to use this
operation.
5 Envelope Mode is NO-SUS
5 Amp Envelope's Level 1 and 2 are 1 or
greater
5 Amp Envelope's Times are Time 3 > Time4
Increases the proportion by which the
EQ's HighGain is lowered by the amount
of pedal.
With a setting of "0, " this has no effect.
Turn this on to match the phrase loop
with the clock (tempo).
* This is enabled with when you select
a waveform for which a tempo (BPM)
is shown.
47