Table of Contents
Advertisement
Using the Vocal Designer Model Expansion
Selecting a Tone
1 .
Press the [MODEL BANK] button.
The MODEL BANK top screen appears.
Model/category
Model name/category name
Tone name
Tone number
Use the [ Ç SELECT É ] knob to move the cursor to the
2 .
model name/category name.
3 .
Use the [- VALUE +] knob to select "Vocal Designer".
Use the [ Ç SELECT É ] knob to move the cursor to the
4 .
tone number.
5 .
Use the [- VALUE +] knob to select the tone.
MEMO
Move the cursor to the model name/category name or the tone
number and press the [ENTER] (INIT) button. The tone list appears.
6 .
Press the [ENTER] (INIT) button to select the tone.
Setting the Part
Only "PART 1" can be used to select parts for the Vocal Designer.
Follow the steps below to set the current part to "PART 1".
1 .
On the SCENE top screen, press the [PART/FUNC]
button to enter the part select mode.
2 .
Press the PART / OSC SELECT [1] button to set the
current part to "PART 1".
6
Setting the Model Bank
Registering the Vocal Designer to a model
bank
1 .
Hold down the [MODEL BANK] button and press a
model bank button ([1]–[16]).
Use the [ Ç SELECT É ] knob to move the cursor to
2 .
"Attr".
3 .
Use the [- VALUE +] knob to select "MODEL".
Use the [ Ç SELECT É ] knob to select where to
4 .
register the Vocal Designer.
5 .
Use the [- VALUE +] knob to select "Vocal Designer".
6 .
If you want to save the setting, execute the System
Write operation.
6-1 .
Hold down the [SHIFT] button and press the [MENU] (WRITE)
button.
The WRITE MENU screen appears.
6-2 .
Use the [ Ç SELECT É ] knob to select "SYSTEM", and then press
the [ENTER] (INIT) button.
6-3 .
To execute, press the [ENTER] (INIT) button.
Selecting a Vocal Designer tone using the
model bank
1 .
Press the [MODEL BANK] button.
The MODEL BANK top screen appears.
Use the [1]–[16] buttons to switch to tone select mode.
2 .
Select the model bank where you registered the
Vocal Designer by pressing one of the [1]–[16]
buttons.
The tones for the Vocal Designer are shown.
You can use the [- VALUE +] knob to select a tone on this screen as
well.
3 .
Press the [ENTER] (INIT) button.
A list of tones is shown.
4 .
Use the [- VALUE +] knob to select the tone.
You can use the [ Ç SELECT É ] knob to select the tone quickly.
5 .
Press the [ENTER] button.
The tone is now selected.
Advertisement
Table of Contents
