Midi; Audio; Midi-Related Settings; Adjusting The Volume Of The Audio Input And Usb 14 Specifying The Tone Frequencies - Roland TD-25 Parameter Manual

Setup

MIDI

MIDI-Related Settings

* These settings are shared by all of the drum kits.
Parameter Explanation
MIDI Channel Specifies the transmit/receive channel of the drum kit (Default: CH10).
If this is "OFF, " the TD-25's pads are disconnected from its internal sound generator.
Local Control
Normally you will leave this "ON" (Default: ON).
If this is "ON, " a program change message is transmitted when you switch drum kits
Program Change Tx
(Default: ON).
If this is "ON, " program change messages can be received to switch drum kits
Program Change Rx
(Default: ON).
Control change used for transmitting/receiving the depth to which the hi-hat pedal
HHPedal CC
pressed.
Snare CC
Control change used for transmitting/receiving the strike position of the snare, ride, and
Ride CC
AUX.
AUX CC
This setting lets you transmit MIDI messages that are appropriate for the MIDI sound
module you're using.
The note number transmitted when you strike the hi-hat will change depending on the
amount of pressure on the hi-hat pedal.
HH Note# Border allows you to adjust the pedal position at which the Control Change
HH Note# Border message value switches from the open hi-hat to the closed hi-hat. As you monitor
the note number transmitted by the TD-25 and the Control Change message value,
adjust the setting until the note number is switched at the pedal position you want
(Default: 90).
* If you change the HH Note# Border setting, the actual hi-hat performance may not
match the playback of the recorded MIDI data.

Audio

Adjusting the Volume of the AUDIO INPUT and USB
Parameter Explanation
AUDIO IN Gain (dB) Adjusts the volume of the AUDIO INPUT jack.
USB Input Gain (dB)
Adjusts the volume of the sound received from the computer via USB audio.
USB Output Gain (dB) Adjusts the volume of the sound sent to the computer via USB audio.
Specifying the TONE Frequencies
Parameter Explanation
TONE BASS Freq (Hz)
Specifies the frequency that is adjusted by the TONE [BASS] knob.
TONE TREBLE Freq (Hz) Specifies the frequency that is adjusted by the TONE [TREBLE] knob.

Audio REC Settings

Parameter Explanation
If this is "OFF, " the click is not recorded (Default: ON).
AUDIO REC Click Record
This is forcibly turned "OFF" if "Backing Record" is "OFF. "
AUDIO REC Backing
If this is "OFF, " the backing sound is not recorded (Default: ON).
Record
14