Agilent Technologies InfinityLab LC Series User Manual page 92

4 Preparing the Sampler/Collector
Setting up the Sampler/Collector with the Instrument Control Interface
Table 14 Fraction Valve User Interface
Parameter
1290 Infinity II Preparative Open-Bed Sampler/Collector User Manual
Description
Context Menu
The context menu of the dashboard panel contains
the following commands:
• Method:
Displays the Fraction Collector's Method Setup
dialog box.
• Identify Device:
Causes the LED on the front of the module to
blink for a few seconds.
• Home Arm:
Moves the robot arm to its home position.
• Reset Fraction Collector:
Sends a reset signal to fraction collector.
During the reset, the fraction collector is in a
Not Ready state.
• Reset Fraction Volumes:
Informs the fraction collector that the collec-
tion bottles and waste bottle are all empty.
• Rinse Needle:
Displays the Rinse dialog box, which allows you
to specify the rinse parameters.
• Modify > Drawer Configuration:
Displays the Modify Drawer Configuration dialog
box, which allows you to view and (if neces-
sary) modify the drawer configuration of your
device.
• Modify > Detector Delay Volumes:
The table lists all potential analog peak detec-
tion sources configured in your instrument. To
modify the delay volume, enter the new delay
volume (in µL) in the Delay Volume (µL) field of
the appropriate peak detector. The changes in
delay volumes are registered when you leave
the dialog box with OK.
• Modify > Linked Pump:
Click the down-arrow and select the pump that
delivers the main flow from the drop-down list.
The list includes all pumps that can be used as
linked pump. Choose None if the pump that
delivers the main flow does not support linking.
92