D-Link DVG-5402G User Manual page 294

DVG-5402G/GF Wireless AC1200 MU-MIMO Dual Band
Gigabit Router with Fiber WAN Port, 3G/LTE Support, 2 FXS
Ports, and USB Port
User Manual
To enable automatic synchronization with a time server, follow the next steps:
1. Move the Enable NTP switch to the right.
2. Specify the needed NTP server or leave the value specified by default in the NTP Servers
section. If you need to specify several servers, click the ADD SERVER button.
3. Select your time zone from the Main time zone drop-down list. To set the time zone in
accordance with the settings of your PC or portable device, click the DETERMINE
TIMEZONE button.
4. Click the APPLY button. The System date and System time fields will be filled in
automatically and the Completed value will be displayed in the Synchronization field.
Additional settings are also available on the page:
Parameter
Get NTP server
addresses using DHCP
Run as a server for the
local network
Time interval between
NTP requests after
synchronization with
NTP server
Time interval between
NTP requests for
unsynchronized NTP
client
Interval value
After specifying the needed parameters, click the APPLY button.
When the router is powered off or rebooted, the system time is reset to the default value.
!
If you have set automatic synchronization for the system time, the internal clock of the
device will be configured after connecting to the Inter net. If you have set the system time
manually, you need to set the time and date again (see above).
Move the switch to the right if NTP servers addresses are provided
by your ISP. Contact your ISP to clarify if this setting needs to be
enabled.
If the switch is moved to the right, the NTP Servers section is not
displayed.
Move the switch to the right to allow connected devices to use the IP
address of the router in the local subnet as a time server.
From the drop-down list, select a time period (in seconds) after
which a request to update the system time will be sent to the NTP
server or leave the Auto value.
A time period (in seconds) after which a request to synchronize the
system time will be sent to the NTP server.
Select the needed value from the drop-down list.
Auto: The time period is defined automatically.
•
Manual: The time period is defined in accordance with the
•
value specified in the Interval value field.
Specify the time period (in seconds). The minimum acceptable value
is 3.
Page 294 of 311
Configuring via Web-based Interface
Description