Notices; Qualified Personnel Only; Disclaimer; Other Tasks - Milnor 30015T6X Installation Manual

Notices

Qualified Personnel Only

— Do not attempt to move, anchor, or remove restraints from the machine unless you are a rig-
ger or technician, as defined above.

Disclaimer

— Pellerin Milnor Corporation is not responsible for damage to the machine after it leaves
the factory. Pellerin Milnor Corporation strongly recommends that the consignee (usually the
owner/management) carefully inspect the machine in its protective wrapping before off-loading
and inspect the uncovered machine after off-loading. If damage occurred in transit, ensure that
the transportation company acknowledges the damage in writing. Submit a damage claim as soon
as possible.

Other Tasks

— This document addresses common tasks that the rigger and technician will perform. Other
tasks, not explained here, can be needed. Information about other tasks is usually provided by the
dealer, the Milnor® Applications Engineering department, or the Milnor® Service department.
Examples are:
• Placement of the machine on a platform, such as for laundry cart clearance or to accommo-
date unusual drain conditions.
• Partial disassembly and reassembly, possible on some models, for movement through small
spaces.

Facility Prerequisites

Required Condition
structural support
protected storage
access to the final location
clearances for machine
movement and maintenance
operational clearances
Pellerin Milnor Corporation
BNWUUI03.R04 0000257899 D.2 B.7 A.4 1/2/20 2:19 PM Released
BNWUUI03.R04 0000257899 D.2 B.7 A.4 1/2/20 2:19 PM Released
BNWUUI03.R04 0000257899 D.2 B.7 A.4 1/2/20 2:19 PM Released
BNWUUI03.R04 0000257899 D.2 B.7 A.4 1/2/20 2:19 PM Released
BNWUUI03.R01 0000254786 D.2 B.7 B.4 1/2/20 2:19 PM Released
Supporting Information
See document BNUUUI01 "Vital Information About the Forces
Imparted to Supporting Structures by Laundering Machines"
which can be found in the installation manual and also at
https://milnor.sharefile.com/d-s8408ba617d244d98.
If the machine must be stored temporarily, it must be protected
from dampness and excessive temperatures.
See the machine dimensional drawing, which can be found at the
end of the installation manual, for overall dimensions. Partial dis-
assembly is sometimes possible. Contact the Milnor
department.
See the dimensional drawing.
Adequate clearance around controls and for movement of laundry
equipment such as carts. See the dimensional drawing.
Installation Procedures
® Service
25