Performaa Rac Switchtips - Graco PerformAA 15 Instructions - Parts Manual

PerformAA RAC SwitchTips

PerformAA RAC models are compatible with the
following RAC spray tips:
LTX RAC Spray Tips (LTXxxx): Recommended for
high pressure RAC spray gun models.
FFLP Fine Finish Low Pressure (FFLPxxx):
Recommended for low pressure, fine finish applications
for less over-spray and a consistent finish.
LTX and FFLP SwitchTips are the typical tips chosen,
but the PerformAA RAC is also compatible with Low
Pressure (LPxxxx) and Wide (WRxxxx) tips.
* Fluid Output
2000 psi
(14.0 MPa, 140
Orifice Size in. bar)
(mm) fl oz/min (lpm)
LTX RAC Spray Tips
0.009 (0.229) 11.2 (0.33)
0.011 (0.279) 16.6 (0.49)
0.013 (0.330) 23.3 (0.69)
0.015 (0.381) 30.8 (0.91)
0.017 (0.432) 39.5 (1.17)
0.019 (0.483) 49.7 (1.47)
0.021 (0.533) 60.5 (1.79)
0.023 (0.584) 72.7 (2.15)
0.025 (0.635) 85.9 (2.54)
0.027 (0.686) 100.0 (2.96)
0.029 (0.737) 115.6 (3.42)
0.031 (0.787) 131.8 (3.90)
0.033 (0.838) 149.4 (4.42)
0.035 (0.889) 168.4 (4.98)
FFLP Fine Finish Low Pressure RAC Spray Tips
0.008 (0.203) 8.8 (0.26)
0.010 (0.254) 13.9 (0.41)
0.012 (0.305) 19.9 (0.59)
0.014 (0.356) 27.0 (0.80)
0.016 (0.406)
0.018 (0.457)
0.020 (0.51)
*Tips are tested in water.
Measured with NO airflow. Air assist will tend to reduce pattern lengths by 1 in. to 2 in.
Fluid output (Q) at other pressures (P) can be calculated by this formula: Q = (0.041) (QT)
output (fl oz/min) from the above table for the selected orifice size.
.
3A8099A
 Maximum Pattern Width at 12 in. (305 mm)
2 to 4 (100) 4 to 6 (150)
109 209
111 211
--- 213
115 215
--- 217
--- 219
--- 221
--- ---
--- 225
--- 227
--- ---
--- 231
--- ---
--- 235
108 208
110 210
112 212
--- 214
--- ---
--- ---
--- ---
Order desired tip, where xxx = 3-digit spray tip Part No.
from the matrix table. Example: Order LTX209 for the
LTX RAC Spray tip with a 0.009 in. (0.229 mm) orifice
and a maximum spray pattern of
Convert PerformAA 50 models to a RAC Model with
RAC Conversion Kit 24C791. Standard and acetal
(solvent resistant) gasket kits are available. See
Reverse-a-Clean Kits, page 56.
in. (mm)
6 to 8 8 to 10 10 to 12
(200) (250) (300)
Spray Tip Part No.
309 409 509
311 411 511
313 413 513
315 415 515
317 417 517
319 419 519
321 421 521
323 423 523
325 425 525
327 427 527
329 429 529
331 431 531
--- 433 533
335 435 535
308 --- ---
310 410 510
312 412 512
314 414 514
--- --- 516
--- --- 518
--- --- 520
Spray Tip Charts
2 to 4 in. (100 mm).
12 to 14 14 to 16 16 to 18
(350) (400)
--- ---
611 ---
613 ---
615 ---
617 ---
619 ---
621 721
623 723
625 ---
627 ---
629 729
631 ---
633 ---
635 735
--- ---
--- ---
612 ---
614 ---
616 ---
618 ---
620 ---
where QT = fluid
P
(450)
---
---
---
---
817
819
821
---
---
827
831
833
835
---
---
---
---
---
---
---
53