Spray Tip Charts; Performaa 15, Performaa 50, And Performaa Airless Spray Tips - Graco PerformAA 15 Instructions - Parts Manual

Spray Tip Charts

Spray Tip Charts

PerformAA 15, PerformAA 50, and PerformAA Airless Spray Tips

To reduce the risk of injury, including skin injection:
• Follow the Pressure Relief Procedure, page 15,
before removing or installing a spray tip or an air
cap.
• Do not use spray tips in the gray shaded area of
the Spray Tip Selection Chart with PerformAA 15
guns.
• Never exceed the maximum working fluid
pressure for your gun model.
All tips in the Spray Tip Selection Tables can be used
with guns rated at or below 1500 psi (10 MPa, 103 bar).
The spray tips in the gray shaded area can only be
used with 5000 psi (34.5 MPa, 345 bar) rated spray
guns.
50
PerformAA models are compatible with the following
spray tips:
AXM Fine Finish Spray Tips (AXMxxx):
Recommended for high finish quality applications. Use
the AXM and GG4 Spray Tip Matrix Table, page 50.
GG4 Industrial Spray Tips (GG4xxx): Recommended
for high wear applications at high pressures. Use the
AXM and GG4 Spray Tip Matrix Table, page 50
AXF Fine Finish Pre-Orifice Spray Tips (AXFxxx):
AXF tips have a pre-orifice that assists in atomizing
sheer thinning materials, including lacquers. Use the
AXF Fine Finish Pre-Orifice Spray Tips Matrix Table,
page 51.
Order desired tip, where xxx = 3-digit number from
matrix Table 1 or 2. Example: AXM611 is the AXM Fine
Finish Spray Tip with a 00.011 in. (0.279 mm) orifice
and a maximum spray pattern of 12 to 14 inches (350
mm).
3A8099A