Graco PerformAA 15 Instructions - Parts Manual page 23

F . 38: Clean outside of gun
IG
9. Clean the fluid cartridge (6) if necessary.
a. Follow the Remove Fluid Cartridge
Procedure, page 34 to remove the fluid
cartridge (6).
Always trigger the gun to remove or tighten the fluid
cartridge to prevent seat damage.
b. Clean with a soft-bristle brush and compatible
solvent.
c. Follow the Install Fluid Cartridge Procedure,
page 35. Torque to 155-165 in-lb (18-19 N•m).
10. Reassemble and install the spray tip (7) and air cap
assembly (8). See Spray Tip and Air Cap Setup,
page 13.
8b
8a
F . 39: Reassemble the spray tip and air cap
IG
3A8099A
NOTICE
5
7
11. Clean the inline fluid filter (14).
a. Unscrew the fluid inlet fitting (15).
b. Remove the inline fluid filter (14) from the fluid
tube assembly (13).
c. Clean or replace.
13
14
F . 40: Clean the inline fluid filter
IG
12. Check the trigger (9) and the fan adjustment (21g)
movement. Lubricate the pivot pin (10), pivot nut
(11), and cartridge needle (6k).
NOTE: the cartridge needle (6k) is behind the trigger
(9).
10, 11
9
F . 41: Check the trigger and fan adjustment knob
IG
Maintenance
15
21g
23