NEC Xen Master Programming Manual page 71

Programming Manual
PBX/CTX Access Code Assignment I
General Description
Use this Memory Block to specify a PBX line PBX/CTX Access Code together with pauses
for outgoing calls.
Display
Data
No.
2 4 : P B X
T I M E
Programming Procedures
1 Go off-line.
BD
2 Press LK1 + LK1 +
3 Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L
to move the cursor right
K I
~ to enter numeric data
Q
to insert a pause
U
to clear all data
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
3-90
Trunk Type Selection
N
Example:
1. Features such as Code Restriction do not operate properly unless a PBX/CTX Access Code is specified. This
limitation applies to PBX lines assigned in Memory Block 3-90 Trunk Type Selection.
2. A pause is not inserted in the number of an outgoing call on a CO line.
3. Up to three numeric characters and three pauses can be specified.
4. A pause cannot be inserted as the first digit or as consecutive digits.
5. A -(dash) is the entry for pause.
PBX/CTX Access Code Assignment I
Setting
Title
Data
A C 0
D I S P L A Y
to access the Memory Block.
Xen System
Intercom Line
Memory Block Name
Xen
PBX
System
PBX Line
System Mode
1
Submode
1
Data No.
24
PC Programming
a
+BA
Default Values
0-
CO Line
May 2003
1-1-24
1 - 53