NEC Xen Master Programming Manual page 28

NEC Business Solutions Ltd
S 3
ECTION
S D L
YSTEM ATA IST
LK 1 System Mode
LK 1 CO Line
Data
Memory Block Name
No.
00 Pause Time Selection
01 DP Interdigit Time Selection
02 Hookflash Time Selection
03 Hold Recall Timer Selection (Non-
Exclusive Hold)
04 Automatic Redial Time Selection
05 Start Timer Selection
06 CO/PBX Incoming Ringing Alarm Time
Selection
07 Tie Line Delay Ringing Timer Selection
09 Manual Pause Selection
11 System Transfer/Camp-On Selection
12 Station Transfer/Camp-On Recall Timer
Selection
13 CO Transfer Ring Pattern Selection
14 CO Transfer Ring Tone Selection
18 System Speed Dial Restriction by
Tenant
19 Line Selection for Automatic Outgoing
Calls
20 DID Digit Length Selection
21 DID Digit Conversion Assignment
1 - 10
The following table provides a complete list of Memory Blocks that are available in
the Xen system. The information is organized by mode, submode, and then
numerically by Memory Block number. The Memory Block number and name, the
default values, and programming values are provided for each Memory Block.
Table 1-3 System Data
Default Value
3 sec.
Pattern B
100 ms.
60 sec.
Calling Time = 30 sec
Waiting Time = 60 sec
Call Attempts = 2 times
10 sec.
No Limit
No Limit
No
Yes
60 sec.
Pattern C
Tone A
Not Restricted
2 Digits
Yes
Xen Master & Xen Axis
Programming Values
1 sec., 3 sec.
Pattern A
10 pps: 650 ms
20 pps: 500 ms
Pattern B
10 pps: 800 ms
20 pps: 800 ms
20 ms., 40 ms., 60 ms.,
80 ms., 100 ms., 140 ms.,
160 ms., 200 ms.
400 ms., 600 ms., 800 ms.,
1 sec., 1.5 sec., 2 sec., 3 sec.,
5 sec.
25 sec., 45 sec., 60 sec., 90 sec., 120 sec.,
180 sec., 240 sec., No Limit
Calling Time: 1~5 sec
Waiting Time: 1~100 sec
Call Attempts: 1~9 times (3 digit input)
2 sec., 10 sec., 20 sec., 30 sec.,
40 sec. , 50 sec., 60 sec., 70 sec.
10 sec., 20 sec., 30 sec., No Limit
10 sec., 20 sec., 30 sec., No Limit
No, Yes
No, Yes
25 sec., 45 sec., 60 sec., 90 sec., 120 sec.,
180 sec., 240 sec., No Limit
Tone Off, Tone On, Patterns A ~ H
Tones A ~ H
LED On: Not Restricted
LED Off: Restricted
2, 3, or 4 digits
No, Yes
Multiline Terminal Programming